Tether Base Installation

Estimated time: under 30 minutes Surface: existing concrete pool deck

Swim Tether Base Installation

Installing the Swim Tether Base Plate in an existing concrete pool deck is straightforward and can typically be completed in under 30 minutes.

Watch Installation Video Download Printable PDF
Important: Let the Base Plate fully cure for 24 hours before use.

Tools & Materials (Step 1)

  • Swim Tether Base Plate
  • Hammer drill (corded recommended)
  • 1-1/8” masonry drill bit (a 1” bit can work if you wallow out the hole)
  • Hydraulic cement or a quality construction adhesive
  • Tape measure
  • Pencil / marker
  • Marking tape

Placement Tips

  • Optimal distance from water’s edge: 6–8 inches
  • Other distances are fine if you compensate with a longer stretch cord
  • Recommended location: shallow end

Shop Custom Length Cords
2

Measure & Mark

Determine the best install location and mark it. The optimal distance from the water’s edge is 6–8 inches. Install in the shallow end when possible.

3

Drill & Clean

Mark your drill bit with tape to indicate a drilling depth of 3 inches. Start slowly with the drill perpendicular to the surface and drill to your 3” mark. Clean out all dust and debris from the hole.

4

Check the Fit

Insert the Base Plate to test fit. If needed, wallow out or drill deeper until it seats easily and sits flush with the concrete surface. Don’t make it too tight—leave room for adhesive.

5

Set the Base Plate

Apply a generous amount of hydraulic cement or construction adhesive inside the hole and around the Base Plate stem. Press firmly and evenly into place while wiping away excess adhesive. Align the Swim Tether logo the way you want.

Do not use for 24 hours. Allow the adhesive/cement to fully cure for 24 hours before using your Swim Tether.
How far from the water should I install it?
The optimal distance is 6–8 inches from the water’s edge. Other distances are acceptable if you compensate with a longer stretch cord.
How deep do I drill?
Drill to a depth of 3 inches. Mark your bit with tape so you can hit that depth accurately.
What if the base plate is too tight?
You don’t want a tight press-fit. Wallow out or drill slightly deeper so the plate seats easily and stays flush, leaving room for adhesive.
Need help?
For installation help, message us through our website.